Philips 50PFL5602/F7 User Manual download pdf (Page 5)

1 Notice

Trademarks are the property of Koninklijke Philips N.V. or their respective

owners.

P&F USA reserves the right to change products at any time without being

obliged to adjust earlier supplies accordingly.

The material in this manual is believed adequate for the intended use of

the system. If the product or its individual modules or procedures are used

for purposes other than those specified herein, confirmation of their

validity and suitability must be obtained. P&F USA warrants that the

material itself does not infringe any United States patents. No further

warranty is expressed or implied.

P&F USA cannot be held responsible neither for any errors in the content

of this document nor for any problems as a result of the content in this

document. Errors reported to P&F USA will be adapted and published on

the P&F USA support website as soon as possible.

Pixel characteristics

This LCD product has a high number of color pixels. Although it has

effective pixels of 99.999% or more, black dots or bright points of light

(red, green or blue) may appear constantly on the screen. This is a

structural property of the display (within common industry standards) and

is not a malfunction.

Warranty

No components are user serviceable. Do not open or remove covers to

the inside of the product. Repairs may only be done by service centers

and official repair shops. Failure to do so shall void any warranty, stated

or implied.

Any operation expressly prohibited in this manual, any adjustments or

assembly procedures not recommended or authorized in this manual

shall void the warranty.

Federal communications commission notice

This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or

more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and the receiver.

•

Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

•

Consult the dealer or an experienced radio or television technician for

help.

Declaration of conformity

Trade name

: PHILIPS

Responsible party

: P&F USA, Inc.

Model

: 65PFL5602, 55PFL5602, 50PFL5602,

43PFL5602

Address

: 1880 Braselton Hwy, Suite 118 #5012

Lawrenceville, GA 30043 U.S.A.

Telephone number

: 1 866 202 5960

Modifications

This apparatus may generate or use radio frequency energy. Changes or

modifications to this apparatus may cause harmful interference.

Any modifications to the apparatus must be approved by P&F USA.

The user could lose the authority to operate this apparatus if an

unauthorized change or modification is made.

Cables

Connections to this device must be made with shielded cables with

metallic RFI / EMI connector hoods to maintain compliance with FCC

Rules and regulations.

Canadian notice

CAN ICES-3 (B)/NMB-3 (B)

Analog and digital television receiving apparatus, Canada BETS-7 /

NTMR-7.

The following FCC/IC RSS applies to the wireless LAN

adapter included in this product.

FCC caution: Any changes or modifications not expressly approved

by the party responsible for compliance could void the user’s

authority to operate this equipment.

This transmitter must not be co-located or operating in conjunction

with any other antenna or transmitter.

Country code statement

For product available in the USA market, only channel 1a1 1 can be

operated. Selection of other channels is not possible.

To maintain compliance with FCC RF exposure requirements, use

only belt-clips, holsters or similar accessories that do not contain

metallic components in its assembly. The use of accessories that do

not satisfy these requirements may not comply with FCC RF

exposure requirements and should be avoided.

This device complies with Part 15 of FCC Rules and Industry Canada

licence-exempt RSS standard(s). Operation is subject to the

following two conditions: (1) this device may not cause interference,

and (2) this device must accept any interference, including

interference that may cause undesired operation of this device.

5150-5250 MHz band is restricted to indoor operations only.

High-power radars are allocated as primary users (i.e. priority users)

of the bands 5250-5350 MHz and 5650-5850 MHz and that these

radars could cause interference and/or damage to LE-LAN

devices.

Compliance with IC requirement RSS-210 A9.4.4

Data transmission is always initiated by software, which is the

passed down through the MAC, through the digital and analog

baseband, and finally to the RF chip. Several special packets are

initiated by the MAC. These are the only ways the digital baseband

portion will turn on the RF transmitter, which it then turns off at the

end of the packet. Therefore, the transmitter will be on only while

one of the aforementioned packets is being transmitted. In other

words, this device automatically discontinue transmission in case

of either absence of information to transmit or operational failure.

5 .English

1 2 3 4 5 6 7 8 9 10 ... 59 60

Comments to this Manuals

No comments

Philips 50PFL5602/F7 User Manual Page 5

Comments to this Manuals

Related products and manuals for LED TVs Philips 50PFL5602/F7