Philips WACS7000 User Manual download pdf (Page 56)

English

15. Gracenote CD Information

The Gracenote music recognition service enables

the set to look up CD track information

(including album, artist, genre, track information)

from its built-in database. It allows the recorded

CD tracks to be properly categorized (for

example, under Artists, Albums, Genres or All

tracks) and also be merged with the existing

tracks in the hard disk.

15.1 Gracenote music

recognition database

A 800 MB CD database (contains 800,000 most

popular CDs) is embedded in every WACS7000

Center for quick look-up on track information.

An update ﬁle that contains newly released CDs

is available quarterly on www.club.philips.com for

download.

15.1.1 To update Gracenote music

recognition database

1 Use your PC to register your product on

www.club.philips.com and go to "Show Upgrades

& Support" page to download Gracenote Music

recognition database update. Note that the

updates are posted quarterly and each update is

independent of each other, i.e. a later update

could be installed without an earlier update.

2 After storing the ﬁle on your PC, you can either

burn a CD with the update ﬁle using your

favorite CD burning software and drop the CD

into the WACS7000 Center for automatic

update, or you can use WADM's Gracenote

update option if you have connected your PC to

WACS7000 Center.

15.2 Gracenote Internet Query

If the CD track information of your new CD disc

cannot be displayed on the WACS7000, the

quickest and surest solution is to look it up from

the internet by following steps below.

15.2.1 Connecting to the

Internet

Check that you have connected the Center to an

Access Point or Router with Internet access or

connect the Center to an ADSL modem with

internet access directly

Helpful hint:

– Make sure that no dial-up, user name or

password is required for the Internet access.

2 Set DNS and Gateway

● If you are using a DHCP* enabled Access

Point, Router or ADSL modem, the DNS and

Gateway can be got automatically, so you need

only to set the Center to Automatic (DHCP)

mode by following steps below:

*DHCP stands for Dynamic Host Conﬁguration Protocol. It is a

protocol for assigning dynamic IP addresses to devices on a network.

a. Press MENU

b. Press 3 or 4 and 2 to select Settings

➛Network ➛ Wired

c. Press 2 to continue

d. Press 3 or 4 and 2 to select Automatic

(DHCP).

● If there is no DHCP, set the DNS and Gateway

manually by following steps below:

On your PC, carry out the following steps:

a. Click Start > Run

b. Type cmd and click OK

c. Type ipconﬁg/all

d. Write down the DNS and Gateway of the

current connection

ETHERNET

Wireless Base Station 11g T

rue T

urbo

Wireless

Modem PC

Power

Internet

for illustration only

External wired network

DSL modem

Router

For illustration only

pg001-pg064_WACS7000_97 2006.12.14 2:02 PM Page 56

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 64 65

Comments to this Manuals

No comments

Philips WACS7000 User Manual Page 56

Comments to this Manuals

Related products and manuals for Home audio sets Philips WACS7000