Philips MCD295 User Manual download pdf (Page 36)

36

English

Clock/Timer

Clock setting

See "Preparations-Step 2: Setting the clock".

Timer setting

● The system can be used as an alarm clock,

whereby the last selected source is switched on

at a set time (one time operation). The clock

time needs to be set first before the timer can

be used.

1 In standby mode, press and hold TIMER for

more than three seconds.

➜ "SET TIMER" is displayed briefly. Then, the

hour digits flash on the display panel.

2 Tu rn the VOLUME control on the front panel

or press VOLUME +/- on the remote to set

the hours and press TIMER to confirm.

➜ The minute digits flash on the display panel.

3 Tu rn the VOLUME control on the front panel

or press VOLUME +/- on the remote to set

the minutes and press TIMER to confirm.

➜ "ON" or "OFF" flashes.

4 Tu rn the VOLUME control on the front panel

or press VOLUME +/- on the remote to

activate or deactivate the timer and press

TIMER to complete the setting.

➜ Display shows if activated, and disappears

if deactivated.

Sleep timer setting

The sleep timer enables the system to switch off

by itself after a set period of time.

1 Press SLEEP on the remote control repeatedly

to select a preset time.

➜ The selections are as follows (time in

minutes):

00 ™ 10 ™ 20 ™ 30 ™ 40 ™ 50 ™ 60 ™

70 ™ 80 ™ 90™ 00

➜ "SLEEP XX" is displayed. "XX" is the time in

minutes.

2 When you reach the desired length of time, stop

pressing the SLEEP button.

To deactivate the sleep timer

● Press SLEEP repeatedly until "00" is displayed,

or press STANDBY ON y.

pg001-pg040_MCD295-58-Eng 2006.3.24, 17:0236

1 2 ... 31 32 33 34 35 36 37 38 39 40

Comments to this Manuals

No comments