9EN
Prepare the remote control
Caution
• Risk of product damage! When the remote control is
not used for long periods, remove the batteries.
To insert the remote control battery:
1 Open the battery compartment.
2 Insert the supplied AAA battery with
correct polarity (+/-) as indicated.
3 Close the battery compartment.
Power on
Press .
» MCB2305 switches to the last selected
source.
Switch to standby mode
Press again to switch MCB2305 to standby
mode.
» The clock (if set) is displayed on the panel.
• In standby mode, press to switch
between working mode and standby
mode.
Note
• MCB2305 switches to Standby mode after 15 minutes
inactive.
Set the clock
1 In standby mode, press and hold CLOCK
for more than two seconds to enter the
clock setting mode.
» [24 HOUR] (24 hour) or [12 HOUR]
(12 hour) is displayed.
2 Press / to select 24 or 12 hour
format, and then press CLOCK.
» The hour digits begin to blink.
3 Press / to set the hour, and then
press CLOCK.
» The minute digits begin to blink.
4 Press / to set the minute, and then
press CLOCK.
5 Press / to select [SYNC ON] or
[SYNC OFF], and then press CLOCK.
• [SYNC ON]: When you tune to an
RDS station that transmits time signals,
MCB2305 automatically synchronizes
time with the RDS station.
• [SYNC OFF]: Not synchronize the
clock automatically.
» The set clock is displayed.
Note
• To view clock information in working mode, press
CLOCK.
• If no button is pressed in 90 seconds during setting,
MCB2305 exits clock setting without saving earlier
operations.
Comments to this Manuals