Philips 8160XLCC User Manual download pdf (Page 12)

ENGLISH 23ENGLISH22

◗ When the cleaning solution level drops below

the minimum level,the cleaning light will blink

with intervals and the razor holder will move

to the starting position.

◗ If you clean your razor every day,you should

refillthe canister approximately every 15 days.

C 5 Carefully lower the appliance back onto

the Jet Clean canister making sure the

release buttons snap back into place.

Jet Cleaning the Razor

◗ If the razor does not contain enough power

for one (1) shave,the Jet Clean Cleaning

System may not work properly. Charge the

razor in the Jet Clean System before using it

to clean your razor.

◗ The cleaning cycle takes approximately 1 hour

to complete.

C 1 Connect the small plug to the Jet Clean

System. Connect the charging plug into

any 100V to 240V AC outlet. Use only the

charging plug provided.

The razor holder automatically moves up to the

highest position.

2. Place the Jet Clean System on a flat,level

surface. Fill the cleaning canister with

cleaning solution (see ‘Preparing Jet Clean

System For Use’).

C 3 Remove protective razor head cap from

razor.

C 4 Place the razor head side down in the

razor holder so that the razor head fits

into the configuration shown inside the Jet

Clean System.Gently press the base of the

razor towards the back of the Jet Clean

System so that the razor base fits snugly in

place.Lock the razor into place by pushing

the lever down completely.

The charging light will blink to indicate the razor

automatically begins to charge.

C 5 Press the ON/OFF button to start the

cleaning cycle.

The cleaning light on the Jet Clean System starts

blinking and the razor is automatically lowered

into the cleaning solution.The razor stops

charging while it is cleaning.

◗ During the first phase of the cleaning

cycle,the razor will automatically turn on and

off several times while the razor holder

lowers and raises the razor’s position in the

cleaning solution,removing all debris.The

cleaning light will blink continuously.

◗ During the second phase of the cleaning cycle,

the razor holder moves the razor to the

drying position and the cleaning light will light

up continuously.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments