Philips HR1056/30 User Manual download pdf (Page 9)

1 Put the ingredients in the feeding tube. (Fig. 7)

- Pre-cut large ingredients into pieces that t in the feeding tube.

- Fill the feeding tube evenly for the best results.

- To shred cheese, e.g. Parmesan, Gouda or Emmentaler, the cheese should be at refrigerator

temperature.

Note: Certain ingredients may cause discolouration. If you spill ingredients on the outside of the Cutting

Tower, wipe away the spills immediately.

2 Put the pusher onto the ingredients in the feeding tube (Fig. 8).

3 Turn the control knob to speed 1 or 2 and push down the pusher. (Fig. 9)

Use speed 1 for soft ingredients like mushrooms. Use speed 2 for hard ingredients like carrots.

Cleaning

Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone

to clean the appliance.

1 Switch off and unplug the appliance.

2 Turn the lid with feeding tube anticlockwise to remove it from the bowl with spout.

3 Lift the disc holder and the tool holder out of the bowl with spout.

4 Remove the disc from the disc holder.

5 Turn the bowl with spout anticlockwise to remove it from the motor unit.

6 Clean the bowl with spout, the lid with feeding tube, the pusher, the tool holder, the disc

holder and the discs with warm water and some washing-up liquid or in the

dishwasher. (Fig. 10)

Clean the discs very carefully. The cutting edges are very sharp.

7 Wipe the motor unit with a moist cloth. (Fig. 11)

Danger: Never immerse the motor unit in water, nor rinse it under the tap. Do not clean it in the

dishwasher either.

Caution: If water or another liquid end up between the motor unit and the bowl with spout, dry

the motor unit properly before you use the appliance again.

Storage

1 Wind the mains cord around the cord storage compartment facility in the bottom of the

motor unit.

2 Put the bowl with spout on the motor unit (1) and turn it clockwise (2) to x it

(‘click’) (Fig. 2).

3 Put the tool holder in the bowl with spout (1). Put the lid with feeding tube on the bowl with

spout (2) and turn it clockwise (3) to x it (‘click’) (Fig. 12).

4 Put the pusher in the feeding tube. (Fig. 13)

5 Store the appliance on a dry, at and stable surface and the discs in a safe, dry place out of

the reach of children.

ENGLISH 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

No comments

Philips HR1056/30 User Manual Page 9