Philips MCD515/37 User Manual download pdf (Page 21)

English

Preparations

IMPORTANT!

– Make sure to complete the

preparation procedures before operating

the system.

Step 1: Inserting batteries into

the remote control

1 Open the battery compartment.

2 Place two batteries (Type R06 or AA) in the

compartment with the correct polarity as

indicated by “+” and “–” symbols.

3 Close the cover.

Using the remote control to operate the

system

1 Point the remote control directly at the remote

sensor (iR) on the front panel.

2 Select the source you wish to

control by pressing one of the

source select buttons on the

remote control (for example

DISC, TUNER).

3 Then select the desired function

(for example 2;, í, ë).

CAUTION!

– Remove batteries if they are

exhausted or will not be used for a long

time.

– Do not use old and new or different

types of batteries in combination.

– Batteries contain chemical substances,

so they should be disposed of properly.

Step 2: Setting the clock

1 Go to Standby mode.

2 Press and hold CLOCK SET on the front

panel.

➜ “SET CLOCK” is displayed briefly. Then, the

hour digits flash on the display screen.

3 Tu rn the VOLUME control on the front panel

or press VOL +/- on the remote to set the

hours.

4 Press CLOCK SET again.

➜ The minute digits flash on the display screen.

5 Tu rn the VOLUME control on the front panel

or press VOL +/- on the remote to set the

minutes.

6 Press CLOCK SET to confirm the clock

setting.

Notes:

– This system only supports 24-hour mode.

– The clock setting will be erased when the system

is disconnected from the power supply.

– The system will exit clock setting mode if no

button is pressed within 30 seconds.

PRESET

pg001-pg042_MCD515-37-Eng 2006.2.27, 16:2121

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 41 42

Comments to this Manuals

No comments

Philips MCD515/37 User Manual Page 21

Comments to this Manuals

Related products and manuals for DVD players Philips MCD515/37