Philips MCD289 User Manual download pdf (Page 12)

12

English

Installation

IMPORTANT!

– The type plate is located at the rear of

the system.

– Before connecting the AC power cord

to the wall outlet, ensure that all other

connections have been made.

–Never make or change any

connections with the power switched on.

Step 1: Connecting speakers

1 Place the main set with the front side facing

down on a flat and firm surface. Then remove

the detachable cover on the back of the set to

expose the terminals available for connection.

2 Connect the two front speaker cables to the

SPEAKERS terminals: right speaker to "RIGHT"

and left speaker to "LEFT".

Notes:

– Ensure that the speaker cables are correctly

connected. Improper connections may damage the

system due to short-circuit.

–For optimal sound performance, use the

supplied speakers.

– Do not connect more than one speaker to any

one pair of +/- speaker terminals.

– Do not connect speakers with an impedance

lower than the speakers supplied. Please refer to

the SPECIFICATIONS section of this manual.

Connecting the wireless subwoofer

● Power on both the main set and subwoofer.

➜ Wireless connection will set up automatically.

In case the wireless connection fails due

to conflict or strong interference etc.,

you may need the following procedures

for manual pairing:

1 In standby mode, press and hold 2; on the set

for three seconds.

➜ “PAIRING” flashes on the display screen.

2 Press and hold the PAIR button on the rear of

the subwoofer for three seconds.

➜ The LED indicator on the subwoofer flashes.

● If the connection succeeds, the display shows

“PAIR OK”.

● If the connection fails or the connection cannot

be set up successfully within 60 seconds, the

display shows “PAIR FAIL”.

Notes:

– The wireless connection will be disconnected

automatically after power-off.

– See “Basic Functions - Switching the system to

Eco Power Standby mode” for how to switch

between Eco Power Standby mode and standby

mode.

Step 2: FM antenna connection

● Connect the supplied FM antenna to the FM

AERIAL terminal.

Step 3: Connecting TV

IMPORTANT!

–You only need to make one video

connection from the following options,

depending on the capabilities of your TV.

pg001-pg018_MCD289-12-Eng-A 2008.1.24, 14:3712

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Comments to this Manuals

No comments