Philips CEM2250 User Manual download pdf (Page 8)

English

3 Install the car

audio

These instructions are for a typical installation.

However, if your car has different requirements,

make the corresponding adjustment. If you have

any questions regarding installation kits, consult

your Philips car audio dealer.

Caution

• This unit is designed for negative ground (earth) 12 V

DC operation only.

• Always install this unit in the car dashboard. Other

locations can be dangerous as the rear of the unit heats

up during use.

• To avoid short-circuit: before you connect, ensure that

the ignition is off.

• Ensure that you connect the yellow and red power

supply leads after all other leads are connected.

• Ensure that all loose leads are insulated with electrical tape.

• Ensure that the leads do not get caught under screws

orin parts that will move (e.g. seat rail).

• Ensure that all ground (earth) leads are run to a

common ground (earth) point.

• Use only the supplied mounting hardware for a safe

and secure installation.

• Improper fuses can cause damage or re. When you

need to change the fuse, consult a professional.

Note on the power supply lead (yellow)

• When you connect other devices to this

apparatus, ensure that the rating of the car

circuit is higher than the total fuse value of

all the connected devices.

Notes on speaker connection

• Never connect speaker wires to the metal

body or chassis of the car.

• Never connect speaker wires with stripes

to one another.

Connect wires

Caution

• Ensure that all loose leads are insulated with electrical tape.

Note

• Consult a professional to connect CEM2250 as

instructed below.

1 Check the car's wiring carefully and connect

them to the the supplied male connector.

Note

• Risk of danger! Please consult a professional to perform

the below steps!

ISO male connectors Connect to

1 Green strip, black-edged

green strip

Left speaker

(Rear)

2 White strip, black-edged

white strip

Left speaker

(Front)

3 Gray strip, black-edged

gray strip

Right speaker

(Front)

4 Purple strip, black-edged

purple strip

Right speaker

(Rear)

e Red Ignition key +12V

DC when ON/

ACC

f Blue Motor/electric

antenna relay

control lead

g White edged blue strip Amplier relay

control lead

h Black Ground

i Yellow To the +12V car

battery which is

energized at all

times

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Comments to this Manuals

No comments

Philips CEM2250 User Manual Page 8

Comments to this Manuals

Related products and manuals for Car media receivers Philips CEM2250