Philips AX7104/00C User Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 6
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
Troubleshooting
No sound or bad sound quality.
PAUSE might be active. Press 2;.
Loose, wrong or dirty connections. Check and clean connections.
Volume might not be appropriately adjusted. Adjust the volume.
Strong magnetic fields. Check player’s position and connections. Also keep
away from active mobile phones.
For in-car use,
check that the cassette adapter is inserted correctly, that the
car cassette player’s playback direction is correct (press autoreverse to
change), and that the cigarette lighter jack is clean. Allow time for tempera-
ture change.
TROUBLESHOOTING
WARNING: Under no circumstances should you try to repair the set yourself as
this will invalidate the warranty. If a fault occurs, first check the points listed,
before taking the unit for repair. If you are unable to solve a problem by following
these hints, consult your dealer or service center.
The CD player has no power, or playback does not start
Check that your batteries are not dead or empty, that they are inserted
correctly, that the contact pins are clean.
Your adapter connection may be loose. Connect it securely.
For in-car use,
check that the car ignition is on. Also check player’s batteries.
The indication no diSC is displayed
Check that the CD is clean and correctly inserted (label-side upward).
If your lens has steamed up, wait a few minutes for this to clear.
The indication nF diSC is displayed
CD-RW (CD-R) was not recorded properly. Use FINALIZE on your CD-recorder.
The indication
HOLD is on and/or there is no reaction to controls
If HOLD is activated, then deactivate it.
Electrostatic discharge. Disconnect power or remove batteries for a few sec-
onds.
The CD skips tracks
The CD is damaged or dirty. Replace or clean the CD.
RESUME, SHUFFLE or PROGRAMis active. Switch off whichever is on.
CAUTION
Use of controls or adjustments or performance of procedures other than
herein may result in hazardous radiation exposure or other unsafe
operation.
Troubleshooting
Page view 5
1 2 3 4 5 6

Comments to this Manuals

No comments