Philips BDP2930/05 User Manual download pdf (Page 20)

20 EN

!#$*&&%

 Visible and invisible laser radiation when

open. Avoid exposure to beam.

 Do not touch the disc optical lens inside

the disc compartment.

 

on power cords or on other electrical

equipment.

 If the product is transported in

temperatures below 5°C, unpack the

product and wait until its temperature

matches room temperature before

connecting it to the power outlet.

!#$%

 

space. Always leave a space of at least four

inches around the product for ventilation.



never cover the ventilation slots on the

product.

!#$%

 Do not mix batteries (old and new or

carbon and alkaline, etc.).

 Remove batteries if they are exhausted or

if the remote control is not to be used for

a long time.

 Batteries contain chemical substances, they

should be disposed of properly.

!#$88;%

 The product/remote control may contain a

coin type battery, which can be swallowed.

 Keep the battery out of reach of children

at all times!

CLASS 1

LASER PRODUCT

Important notes for users in

the U.K.

Mains fuse

This information applies only to products with a

UK mains plug.



molded plug. If you replace the fuse, use one

with:

 the ratings shown on the plug,

 a BS 1362 approval, and

 the ASTA approval mark.

Contact your dealer if you are not sure about

what type of fuse to use.

Caution: To conform with the EMC directive

(2004/108/EC), do not detach the plug from

the power cord.

How to connect a plug

The wires in the power cord are colored as

follows: blue = neutral (N), brown = live (L).

If the colors do not correspond with the colors

on your plug, identify the terminals in your plug

as follows:

1 Connect the blue wire to the terminal

marked N or colored black.

2 Connect the brown wire to the terminal

marked L or colored red.

3 Do not connect either wire to the earth

terminal in the plug, marked E (or e) or

colored green (or green and yellow).

Before you replace the plug cover, make sure

that the cord grip is clamped over the sheath



the cable.

Copyright in the U.K.

 Recording and playback of material may

require consent. See Copyright Act 1956

and The Performer’s Protection Acts 1958

to 1972.

BDP2900_05_UM_EN_V1.0.indd 20 2012-2-17 16:12:13

1 2 ... 15 16 17 18 19 20 21 22 23 24 25

Comments to this Manuals

No comments