www.philips.com/supportUser manualAlways there to help youRegister your product and get support atAJT5300Question?Contact Philips
8 EN6 Use Bluetooth devicesWith this clock radio, you can listen to audio from Bluetooth-enabled devices and control the incoming call through Blueto
9ENControl your phone callAfter Bluetooth connection, you can control your incoming phone call with this product.Button FunctionPress to answer an inc
10 EN7 Other featuresCharge your phoneWith this clock radio, you can charge your phone through the USB socket.1 Connect your phone and the clock rad
11EN To deactivate the sleep timer:• Press repeatedly until [OFF] (off) appears.Tip •If you press in standby mode, the clock radio will switch to
12 EN8 SpecificationsNote •Product information is subject to change without prior notice.Rated output power (Amplier): 2.7W RMS @ 10% THDAcoustic fre
13EN9 TroubleshootingWarning •Never remove the casing of this device.To keep the warranty valid, never try to repair the system yourself. If you encou
14 EN10 NoticeAny changes or modications made to this device that are not expressly approved by Gibson Innovations may void the user’s authority to o
Specicationsaresubjecttochangewithoutnotice.Copyright © 2016 Gibson Innovations Limited. Revised Edition © 2017This product has been manufactur
1ENContents1 Important 2Know these safety symbols 22 Your clock radio 3Introduction 3What's in the box 3Overview of the clock radio 43 Get
2 EN1 ImportantKnow these safety symbols This ‘bolt of lightning’ indicates uninsulated material within your unit may cause an electrical shock. For
3EN2 Your clock radioCongratulations on your purchase, and welcome to Philips! To fully benet from the support that Philips offers, register your pr
4 ENOverview of the clock radio a SCAN/ • Press to set sleep timer.• Press and hold for two seconds to store radio stations automatically.b SOURC
5EN3 Get startedAlways follow the instructions in this chapter in sequence.Install batteryThe batteries can only back up clock and alarm settings whe
6 EN4 Set time and alarmSet timeNote •You can only set time in standby mode.1 Press and hold SET TIME for two seconds to activate time setting mode.
7EN5 Listen to FM radioPrepare FM antennaFor better reception, fully extend and adjust the position of the pig-tail antenna. Note •To prevent inter
Comments to this Manuals