Philips FWD876 User Manual download pdf (Page 37)

37

English

Clock/Timer Operations

Viewing the clock

The clock (if it is set) will be shown in standby

mode.

To view the clock in any source mode

(DISC or TUNER) for example:

● Press CLOCK on the system.

➜ The clock is displayed for a few seconds.

➜ If the clock has not been set, "NO CLOCK" is

displayed for a few seconds.

Setting the clock

1 In standby mode, press and hold CLOCK on

the system,

➜ The clock digits flash on the display panel.

➜ If the clock has not been set, "--:--" flashes

2 Press ¡ / ™ repeatedly to set the hour.

3 Press à / á repeatedly to set the minute.

4 Press DISPLAY/OSD repeatedly to switch to

between 12-hour and 24-hour display.

5 Press CLOCK again to store the setting.

➜ The clock starts working.

Notes:

– The clock setting will be erased when the system

is disconnected from the power supply.

– The system will exit clock setting mode if no

button is pressed within 10 seconds.

–To exit clock setting without storing, press STOP

on the system to exit.

Setting the wake-up timer

The system can switch on to DISC ,USB, TUNER

or TAPE mode automatically at a preset time,

serving as an alarm to wake you up.

IMPORTANT!

– Before setting the timer, ensure that

the clock is set correctly.

–To set a new timer, you need to

deactivate the previously set timer.

1 In standby mode, press and hold TIMER/

SLEEP on the remote for more than five

seconds to enter timer setting mode.

➜ The source and timer digits will be light on

the display panel.

2 Press DISC,USB,TUNER, TAPE/AUX to

select the desired source.

● Before setting timer, make sure the music source

has been prepared.

DISC – load the disc(s).

USB – insert a USB driver.

TUNER – tune to the desired radio station.

TAPE – Insert a recorded tape.

3 Press ¡ / ™ repeatedly to set the hour.

4 Press à / á repeatedly to set the minute.

5 Press TIMER/SLEEP to store the time.

● At the preset time, the selected source will be

played.

Viewing the timer

1 In standby mode, Press TIMER/SLEEP to view

timer (e.g “DISC 03:30“), Timer will be shown

on the display for a few seconds and then go

back to it’s previous status.

2 If timer have not been set, “TIMER OFF” will

be displayed for a few seconds.

To deactivate the wake-up timer

● In standby mode, press TIMER/SLEEP to the

view timer mode, then press STOP until “

TIMER OFF “ is displayed on the panel. ( press

STOP again to switch to “TIMER ON“ )

Notes:

– The system will exit timer setting mode if no

button is pressed within 10 seconds.

– Display shows if activated, and disappears if

deactivated.

Setting the sleep timer

The sleep timer enables the system to switch off

by itself after a set period of time.

1 Press TIMER/SLEEP on the remote control

repeatedly to select a preset time.

➜ The selections are as follows (time in

minutes):

15 ™ 30 ™ 45 ™ 60 ™ 90 ™120 ™ OFF

2 Press TIMER/SLEEP until you reach the

desired length of time.

To deactivate the sleep timer

● Press TIMER/SLEEP repeatedly until "OFF" is

displayed, or press the STANDBY ON y

button.

pg047-pg055_FWD876-Eng-98 2007.12.28, 9:4237

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 46 47

Comments to this Manuals

No comments