VGA Retro CameraLOCATION OF CONTROLS1. Shutter 4. USB connector 7. LCD display/ 1_ ^Viewfinder Mode button1.0 GETTING STARTED1. The device is operat
1. The camera will switch to stand-by mode after 60 seconds of inactivity. The LCD will go blank to help conserve battery power.2. If the camera is
2. Press the Mode button until “HI” appears in the LCD display. Then keep pressing the Shutter button will display the following sequence:Lo ^ HI ^ P
7. Connect the camera to the PC with the USB cable. “Building Driver Information” & “New Hardware found” dialogue box will open and the computer
8.30 Recording AudioIf your laptop has a built in microphone, or if you had installed a microphone on your home PC, you are able to capture the audio
2. “No New Hardware Found” message appears:Make sure the camera and PC are connected properly. Go to “My Computer” icon-> Right click your mouse-&
12.0 SYSTEM REQUIREMENTSPC with Intel Pentium III 800MHz or Higher Microsoft Windows 98SE/ME/2000/XP 128MB RAM or Higher 350MB available hard drive sp
Comments to this Manuals