Industrial Vision Inca 311 Intelligent Camera - 12NC: 8122 410 5680.0 Hardware Manual Philips Applied Technologies
2.3.4 How to use the isolated input/output In this part the user will find how the optical isolation is implemented in the Inca. Not only the digita
2.3.5 Multi-purpose connector Looking at the back of the Inca the connector in the left bottom corner is a multi-purpose connector. The connector, a 9
2.3.6 The display connector The display connector can be used for the connection of a VGA or a CVBS monitor. Only one of these two possibilities can
2005-12-12 Page 11 2.4 POWERING UP When the Inca is powered up, the Inca will boot. One of the first things it will do is to start a self-test to ma
Page 12 2005-12-12 3 SOFTWARE INSTALLATION There is no special software supplied with the Inca for installation purposes, so no installation is neces
4 MECHANICAL INTERFACE For the purpose of installation and handling the camera in an application two mechanical preparations have been made to the cam
Page 14 2005-12-12 5 TROUBLE SHOOTING This chapter describes the action to take if the Inca board does not operate correctly. Moreover, the means of
2005-12-12 Page 15 5.2 SERVICE AND SUPPORT 5.2.1 Service The Inca has built-in identification codes for hard and software in order to facilitate ser
Page 16 2005-12-12 6 TECHNICAL SPECIFICATION Power requirements +8..40V, 8 Watt (max) Typically 12..15 Volt Optics C-mount Mechanical Dimensions
2005-12-12 Page 17 Environmental Inca complies to: EFT immunity: IEC1000-4-4 ESD immunity: IEC1000-4-2 at 4 kV contact discharge and 8
Inca 311 Hardware Manual Version 1.3 A publication of: Philips Applied Technologies Industrial Vision www.apptech.philips.com/industrialvision ©
CONTENTS Inca 311 Hardware Manual ...
Page 2 2005-12-12 1 INTRODUCTION Congratulations on buying the Inca vision system! An Inca is a high quality intelligent camera for image acquisiti
2 HARDWARE The Inca hardware consists of the following modules: • TriMedia processor • CMOS sensor • IEEE 1394 (FireWire™) interface • RS232 seria
2.2 CMOS SENSOR 2.2.1 Inca 311 In the Inca 311 a monochrome sensor PCS2112-LM from Zoran is implemented. This high performance CMOS imaging sensor has
2.3.1 IEEE 1394 (FireWire™) For the interconnection of the Inca camera to the host PC a so-called IEEE 1394 interface, also known as FireWire™, is us
switched to the on position with a positive input, the flash unit will flash or lit continuously. 2.3.2.1 Using the Trigger Input The trigger input i
2.3.3 Digital I/O The Digital Input and Output connectors give the user the possibility to connect and control a number of devices. For that purpose 6
Comments to this Manuals