Signal® Mirror Installation InstructionsFord Taurus 1996-1999, Mercury Sable 1996-1999 THE safety accessory of the 21st Century.™ P/N 210-0031-0 Re
- 5 - USE THE INCLUDED WIRE TAPS AND FOLLOW THE FOUR STEPS ABOVE TO SPLICE INTO THE TURN INDICATOR WIRES 7. Make sure the harnesses are routed
INCLUDED ITEMS: 1 left and 1 right Signal® mirror 1 left and 1 right wire harness 2 wire taps 2 ring connectors 1 instruction manual REQUIRED TOOLS
Door panel removal 1 2 3 4 5 6 7 1. Open door and lower window. 2. Remove screw on outside edge of door. 3. Remove screw
- 2 - 8. Lift door panel up off of door. 9. Disconnect wire from back of mirror control panel. 10. Remove bolt below speaker. 11. Disco
Mirror replacement While using sturdy gloves, position your fingers behind the outboard edge of the mirror. Pull back on the mirror to dislodge it f
Pull the rubber grommet back out from the mirror housing and reposition. Cut a slot in the foam disc just large enough to accommodate th
Wiring - 1 1. Remove the screws around the door speaker. 2. Remove the speaker from the door, disconnect the speaker wire, and set the speaker
5. Pull the rubber boot out from the door frame. 6. There are two holes at the bottom of the rubber boot. Guide the wire harness into one of th
6 16 3 Wiring - 2 5. Guide the new wire harnesses from both sides of the vehicle down to the bottom of the driver side door frame. Roll over
Comments to this Manuals