Philips CMP100/51 User Manual download pdf

www.philips.com/welcome

CMP100

EN User manual

RU Руководствопользователя

dhi

320Hz

30Hz

SUB

WOOFER

SUBSONIC

ON OFF

REMOTE

LEVEL CONTROL

feg

4 ohm speaker

Динамик 4 Ом

4 ohm speaker 4 ohm speaker

Динамик 4 Ом Динамик 4 Ом

Left speaker

Right speaker

White / Black

White

Grey

Grey / Black

Car audio unit

320Hz

30Hz

SUB

WOOFER

SUBSONIC

ON OFF

REMOTE

LEVEL CONTROL

Левый громкоговоритель

Правый громкоговоритель

Автомобильное

аудиоустройство

Белый

Серый

Белый/черный

Серый/черный

LINE OUT

Car audio unit

320Hz

30Hz

SUB

WOOFER

SUBSONIC

ON OFF

REMOTE

LEVEL CONTROL

Автомобильное

аудиоустройство

Линейный выход

to a metal point of the car

Car audio unit

Remote output

Fuse (60 A)

+12 V car battery

less than 450 mm (18 in)

К металлическому контакту в автомобиле

Выход для пульта ДУ

Автомобильное

аудиоустройство

Менее 450 мм (18 дюймов)

Плавкий предохранитель (60 А)

Автомобильный аккумулятор +12 В

C E

320Hz

30Hz

SUB

WOOFER

SUBSONIC

ON OFF

REMOTE

LEVEL CONTROL

REMOTE

LEVEL CONTROL

English

1. Important

Safety

•

Read and understand all instructions before you use the apparatus.

If damage is caused by failure to follow instructions, the warranty does

not apply.

This unit is designed for negative ground (earth) 12 V DC operation only.•

Use only the supplied mounting hardware for a safe and secure installation.•

Do not connect any active speakers (with built-in amplier) to the speaker •

terminals of the unit. Doing so may damage the active speakers.

To ensure safe driving, adjust the volume to a safe and comfortable level.•

To avoid short circuit, do not expose the apparatus to rain or water.•

Never expose the apparatus to direct sunlight, naked ames or heat.•

Clean the apparatus with soft, damp cloth. Never use substances such as •

alcohol, chemicals or household cleaners on the apparatus.

Notice

Environmental information

All unnecessary packaging has been omitted. We have tried to make the

packaging easy to separate into three materials: cardboard (box), polystyrene

foam (buffer) and polyethylene (bags, protective foam sheet.)

Your system consists of materials which can be recycled and reused if disassembled

by a specialized company. Please observe the local regulations regarding the

disposal of packaging materials, exhausted batteries and old equipment.

Any changes or modications made to this device that are not expressly

approved by Philips Consumer Lifestyle may void the user’s authority to

operate the equipment.

Specications are subject to change without notice. Trademarks are the property of Koninklijke Philips

Electronics N.V. or their respective owners. Philips reserves the right to change products at any time

without being obliged to adjust earlier supplies accordingly.

2. Your car power amplier

Congratulations on your purchase, and welcome to Philips! To fully

benet from the support that Philips offers, register your product at

www.philips.com/welcome.

Introduction

With the amplier, you can enjoy high quality sound performance with

powerful bass and beats.

What’s in the box

Check and identify the contents of your package:

a Amplier

b Screw_4x25mm (x4)

c Fuse (x2)

d Hi input connector (x1)

e Volume controller

Overview of the main unit

a INPUT L/R

• Connect car audio with RCA cable.

b HI INPUT

Connect car audio with the supplied high input connector.

•

INPUT LEVEL

Adjust input level (0.3V to 6V).

•

BASS BOOST

Boost the frequencies at around 45Hz to a maximum of 12dB.

•

SUBWOOFER

Adjust low-pass-f

•

ilter frequency for subwoofer.

f PROTECT

Light in red when the PROTECTOR is activated.

•

POWER

Light in blue when power is turned on.

•

h SUBSONIC ON/OFF

Switch on or off the subsonic lter.

•

REMOTE LEVEL CONTROL

External remote

• controller for volume level control.

j POWER (GND/REM/+12V)

Connect +12V DC power cable, ground wire and remote wire.

•

Fuse: 30Ax2

l SPEAKER OUTPUT

Connect to subwoofers.

•

3. Installation

Installation

You can mount the amplier either under a seat or on the rear tray.

Note

To avoid interference, do not place the amplier too close to the car audio or antenna.

•

The supplied mounting screws are 25mm long. Make sure that the mounting

•

board is thicker than 25mm.

Place the unit on the location for installation.

Mark the positions of the four screw holes.

Drill the holes with driller of approximately 4mm in diameter.

Mount the unit with the supplied screws.

Connect speakers

Note

Use speakers with an impedance of 2 to 8 ohm (4 to 8 ohm when used as a •

bridged amplier).

Match the “left”, “right”, “+” and “-” terminals correctly. Revised polarity may

•

degrade sound quality.

Option 1: Mono bridged mode: connect 1 speaker

Option 2: Stereo mode: connect 2 speakers

Connect car audio

Option 1: High level input connection

Connect the amplier to your car audio with the supplied High level

input connector.

Option 2: Line input connection

Connect the amplier to the car audio with a RCA cable (not supplied).

Connect power

Make the power connection as illustrated below:

Connect the ground wire from the car to the • GND socket.

Connect the remote wire from the car audio to the

• REM socket.

√ With this connection, you can turn on/off the amplier

with the car audio.

Connect the power wire from the car battery to the

• +12V socket.

Tip

If your car audio does not have remote output, connect the remote input •

terminal (REM) to the accessory power supply.

4. Use your power amplier

Adjust input level

You can adjust the input voltage from 0.3V to 6V.

Rotate INPUT LEVEL to adjust input voltage.

Adjust bass boost

You can punch extra bass for 0 to 12dB.

Rotate BASS BOOST to punch for extra bass.

About the protector indicator

The amplier has a built-in protection circuit to protect the transistors

and speakers when:

The unit is overheated. Or

•

A DC current is generated. Or•

The battery voltage is over low or over high. Or•

The speaker terminals are short circuited.•

When the PROTECT indicator lights up in red, the unit shuts down

automatically. If this happens, please:

Take out the disc or tape and turn off the car audio.

Check the cause of the malfunction (see above).

If the amplier has overheated, wait until the unit cools down

before use.

Adjust subwoofer frequency

Rotate Subwoofer to adjust low-pass-f

ilter frequency for subwoofer.

Rotate SUBWOOFER to adjust frequency: 30Hz to 320Hz.

Turn subsonic f ilter on or off

Slide SUBSONIC to ON position.

The subsonic is turned on, frequency below 15Hz is f•

iltered.

To turn off the subsonic lter, slide

• SUBSONIC ON/OFF to

OFF position.

Adjust volume

You can adjust volume at the front seat via the supplied volume control.

Connect the supplied volume controller to the REMOTE LEVEL

CONTROL socket.

Rotate the volume knob to adjust volume.

Replace fuse

If there is no power, the fuse may be damaged and need to be replaced.

Pull out the damaged fuse.

Replace the fuse with the supplied fuses or to buy two fuses

that matches the voltage of the damaged fuse (30Ax2).

If the fuse gets damaged immediately after it has been replaced, there

may be an internal malfunction. In such case, consult your Philips dealer.

5. Product information

Note

Product information is subject to change without prior notice.

•

Power Output (RMS)

- 4 ohm

- 2 ohm

250Wx1

400Wx1

Total harmonic distortion 0.08%

Signal to noise ratio 105dB

Frequency response 5-320Hz

Input sensitivity 300mV-6V

Input impedance 22k ohm

Fuse rating 30Ax2

Dimensions (DxWxH) 54.4x336.5x240.2mm

CMP100_51_UM_V2.0_EN+RU.indd 1 12/9/2009 3:07:47 PM

1 2

Summary of Contents

Page 1 - Линейный выход

Register your product and get support atwww.philips.com/welcomeCMP100EN User manualRU Руководствопользователяbadecalkjbcdhi320Hz30HzSUB WOOFERSUBSO

Page 2 - ПРОДАВЦА

6. TroubleshootingTo keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the

Comments to this Manuals

No comments

Philips CMP100/51 User Manual

Browse online or download User Manual for Audio amplifiers Philips CMP100/51. Philips CMP100/51 Руководство пользователя

Summary of Contents

Comments to this Manuals

Related products and manuals for Audio amplifiers Philips CMP100/51